Bunting Tutorial

Sun	Mon	Tue	Wed	Thu	Fri	Sat
	1	2	3	4	5	6
7	8	9	10	11	12	13
14	15	16	17	18	19	20
21	22	23	24	25	26	27
28	29	30

I have a problem - a forgetting problem! I had every intention of bringing my good camera to work with me today but once again I forgot. Yes I could go home and get it, but would have to drive through what looks like to me as the great dust bowl. Plus getting tossed around on the road due to the wind just didn't sound that fun. So my apologizes in advance for the not so stellar photos!

Here we go -

Step 1

Find your favorite iron on transfer (you can find all different shapes for your own bunting here!)

Step 2

Trim about 1/16" around all of the letters. If possible a rotary cutter works pretty slick!

Step 3

Pre-heat your iron to the hottest setting - make sure to turn off your steam!

Step 4

Get your canvas ready for the iron on transfers. I only do 1 or 2 transfers at a time. Cut your canvas into small pieces just enough for 1 or 2 letters to fit on it. Make sure to leave plenty of space in between the letters. Place the iron on transfers face down on the canvas.

Step 5

And Iron! Leave the iron on there for a few seconds. You can test the iron on by pulling up one of the corners of the transfer. A small portion of the ink will remain on the transfer sheet but the majority will be on the canvas. If the transfer needs some more time just place the corner back down and continue ironing. It is very important that the iron is on the hottest setting.